Workbench planning · xTool S1
xTool S1 Table Size and Riser-Base Height Planner
The S1 body is 30.12 × 22.09 × 7.20 in without the riser and weighs 44.1 lb. Its calculated base footprint is 4.62 ft². A 24-inch-deep surface leaves 48.6 mm / 1.91 inches of total nominal depth spare, before any allowance for hoses, cables, lid travel, or service access. This is not clearance on each side or manufacturer-approved operating space.
- Official xTool sources
- Original calculations
- Reviewed 2026-09-09
- No hands-on performance claim
Start with the documented envelope.
30.12 × 22.09 × 7.20 in
765 × 561 × 183 mm
30.12 × 22.09 × 10.55 in
Published installed closed height is 268 mm
4.62 ft²
0.429 m², calculated
44.1 lb / 20 kg
Accessories and workpieces are additional
Bench depth and riser-height arithmetic
- A 24-inch-deep top leaves 48.6 mm / 1.91 in beyond the published 561 mm body depth.
- A 30-inch-wide top is 3 mm / 0.12 in narrower than the published 765 mm machine width.
- The published closed height increases by 85 mm / 3.35 in when the riser is installed.
- The body footprint is 0.429 m² / 4.62 ft² before any operating allowance.
Arithmetic can expose a conflict or tight margin. It cannot establish support suitability, delivery handling, operating clearance, ventilation, electrical capacity, fire protection or code compliance.
Turn the comparison into a measured plan.
- Measure usable bench width, depth, and documented load capacity.
- Choose the exact no-riser, riser, rotary, or conveyor configuration.
- Obtain numeric lid, exhaust, and service requirements where the current source does not provide them.
- Plan material travel independently from the body footprint.
Compare every supported profile
Enter one surface and room zone, then order candidates by evidence and fit rather than price.
Full reportCheck the featured model
Carry the model into delivery, surface, room, exhaust and utility checks.
Complete handoffLaser-room setup checklist
Carry the calculation into delivery, operating space, air path, utilities, materials, and confirmations.
Total costxTool setup-cost builder
Record machine, air-management, attachment, support, site, shipping, tax, and material costs.
Purchase researchxTool buying options
Compare official listings after the room and configuration questions are visible.
Keep these questions unresolved until confirmed.
- No numeric open-lid clearance is published in the cited user guide.
- A body-level pass does not approve a 24-inch bench as the operating surface.
- Riser and conveyor configurations introduce additional access and classification questions.
LaserRoomReady has not physically tested the featured machines. It compares cited room-planning evidence and original calculations only.
Direct answers, with the boundary intact.
Will the S1 body fit on a 24-inch-deep surface?
The 22.09-inch published body depth leaves 1.91 inches, but rear connections, access, and stability still have to be confirmed.
Does the riser make the S1 wider or deeper?
The cited installed dimensions retain 765 × 561 mm width and depth while the closed height changes from 183 to 268 mm.
Manufacturer sources used on this page
Continue only after the room questions are visible.
These merchant links are clearly labeled. LaserRoomReady may earn a commission at no extra cost to you if you buy through one. Compensation does not change the calculations or display order.
xTool S1 40W
30.1 × 22.1 × 7.2 in without riser. Read the evidence and unresolved fields before purchase.
Check today's xTool S1 40W price and options at xTool ↗